Type |
AED9101D | |
Measuring amplifier |
|
AD103C |
Measurement signal input |
mV/V |
±3, nominal ±2 |
Transducer connection: |
W |
40 ¼ 4000 |
SG transducer (full bridge) | ||
Transducer connection type |
|
6‐wire circuit |
Length of transducer cable |
m |
�100 |
Bridge excitation voltage |
VDC |
5 |
Interfaces: Hardware (selected by slide‐switch) Length of communications cable RS‐232 RS‐422, RS‐485 Max. number of bus nodes (RS-485) |
m m |
RS‐232, RS‐422, RS‐485 �15 �1000 32 |
Diagnosis bus (RS‐485 2‐wire) |
kbit/s |
ASCII/binary |
Protocol | ||
Baud rate, max. |
38.4 | |
Node address |
|
0 ¼ 89 |
Length of communications cable, max. |
m |
1000 |
Trigger input |
V |
0 ¼ 1 |
Input voltage range, LOW | ||
Input voltage range, HIGH |
V |
2 ¼ 30 |
Input voltage range at High level = 30 V |
mA |
<3 |
Power supply: |
VDC |
10 ¼ 30 |
Supply voltage | ||
Current consumption (without load cell) |
mA |
�100 1) |
Temperature range: |
°C |
-10 ¼ +40 -20 ¼ +60 |
Nominal (rated) temperature Operating temperature | ||
Storage temperature |
-25 ¼ +85 | |
Dimensions |
mm |
190 x 65 x 40 |
Weight, approx. |
g |
440 (without AD10x) |
Degree of protection per EN 60529 (IEC 529) |
|
IP65 |
AED9101D - datasheet | PDF, 0.51 Kb |