Type |
AED9201B | |
Measuring amplifier |
|
AD103C |
Measuring signal input |
mV/V |
±3, nominal ±2 |
Transducer connection: |
Ω |
≥80...4000 |
Strain gage transducer (full bridge) | ||
Transducer connection |
|
6-wire circuit |
Transducer cable length |
m |
≤100 |
Bridge excitation voltage |
VDC |
5 |
Interfaces: Hardware (selectable via slide switch) Interface cable length RS-232 RS-485 Max. number of bus members |
m m |
RS-232, RS-485 (4 wire) ≤15 ≤1000 90 |
Control inputs (electrically isolated): |
V |
2 |
Number | ||
Input voltage range, LOW |
0...5 | |
Input voltage range, HIGH |
V |
10...30 |
Input current, typ., HIGH-level = 24 V |
mA |
typ. 12 |
Insulation voltage, typ. |
VDC |
500 |
Control outputs 1) (electrically isolated): |
mA |
Supply from supply voltage |
Number |
4 | |
Output current at LOW level (IOUT) |
<2 | |
Output voltage HIGH level (UOUT) |
V |
>15 at Imax |
Output current, max. (IOUTmax) |
mA |
< 500, per output |
Insulation voltage, typ. |
VDC |
500 |
Diagnostics bus: |
kbit/s |
ASCII/Binary |
Protocol | ||
Baud rate, max. |
38.4 | |
Node address |
|
0 ... 89 |
Length of Interface cable, max. |
m |
1000 |
Supply: |
V |
18...30 |
Supply voltage (DC), nominal | ||
Supply voltage (DC), minimal |
V |
15 |
Current consumption (without load cell and |
mA |
≤175 2) |
Output current) | ||
Temperature range: |
°C [°F] |
−10...+40 [+14...+104] −20...+60 [−4...+140] |
Nominal temperature Operating temperature | ||
Storage temperature |
−25...+85 [−13...+185] | |
Dimensions |
mm |
195 x 100 x 70 |
Weight, approx. |
g |
925 (without AD10x) |
Degree of protection according to EN 60529 (IEC 529) |
|
IP65 |
AED9201B - datasheet | PDF, 0.3 Kb |